Christmas decorations - reindeer

Dasher, Dancer, Prancer, Vixen, Comet, Cupid, Donner, Blitzen and, of course, Rudolph.  Reindeer are very much a part of Christmas tradition.  This year I decided to use a reindeer as the design for my felt Christmas decorations.

I previously shared with you some early prototypes of my felt reindeer decorations.  I've now refined and finalised the design.  As I had hoped, pipe cleaners solved the droopy antler issue, and I've also rounded off the ears slightly (a good dose of artistic licence was used in the making of these decorations!).  I hope you like the final result...

 

 

If you want to have a go at making these, you'll need:

• brown felt (there are lots of websites selling felt, I used Colour-Full Felt)
• ribbon (about 8" per decoration, longer if desired)
• black buttons
• red buttons
• thread - brown, black and red
• pipe cleaners
• stuffing (such as this soft toy filling from John Lewis, or you can use scraps of felt cut up into small pieces)
• the templates

The ribbon and red sparkly buttons I used came from John Lewis.  The black buttons and pipe cleaners I sourced from Hobbycraft. 



The head measures approximately 3" (h) x 3 1/2" (from tip-to-tip of ears);
the antler is approximately 3" in length.

* Start by cutting your pieces from the felt, using the templates provided.  You'll need two head pieces and four antler pieces per decoration.  You may find it easier to cut the pieces for the antlers slightly wider then the template (you can then trim these after you have sewn them together).

* Sew, by hand, the buttons for the eyes and nose into place on one of the head pieces.

* Take two antler pieces, lay one on top of the other and, using a sewing machine if you have one, sew carefully around the edges.  Leave a gap at the bottom of the antler so you can insert a pipe cleaner.  Repeat with the other two antler pieces.

* Take one of your antlers and use a pencil or something similar to open up the gap at the bottom of the antler and insert a pipe cleaner, trimming it so it is the length of the antler.  If you find that the pipe cleaner is catching on the inside of the antler, fold over the tip of the pipe cleaner so that there is no sharp wire exposed.  The pipe cleaner should then slide into place, all the way up to the tip of the tallest antler.  Trim the edges to the antler to neaten as desired.  Repeat with the other antler.

* Take the undecorated head piece and lay it on the table.  Place the two antlers on top, between the ears.  Take an 8" length of ribbon, fold, and place between the two antlers.  Then lay the head piece decorated with buttons on the top (correct side up).  Effectively you have a sandwich: the raw edges of the antlers and the ribbon should be sandwiched between the two head pieces.  Pin the ribbon and antlers into place.

* Starting from near the bottom of the head, sew around the edge of the head pieces (use a machine if you have one).  Remember to leave a small gap (about 1") at the end.

* Trim the edges if needed.  Stuff the decoration, using the flat end of a pencil (or something similar) if needed to gently work the stuffing into the ears.  When you are satisfied that it is sufficiently stuffed, sew up the gap by hand using backstitch.

And there you have it, one Christmas reindeer to hang on the tree.